XYZ Racing Drag Racing Coilovers — Lynk & Co 03 2018-2026

The Lynk & Co領克 03 carries most of its mass over the front axle on the Geely-Volvo CMA platform, and that nose-led weight split is exactly what makes a clean launch hard: lift too much load off the driven wheels and the tyres spin before they hook. The XYZ Racing Drag Racing coilover for the Lynk & Co領克 03 is built for one job – getting this saloon off the line and down the strip with the contact patches loaded, not lit up.

This is not a fast-road or circuit setup. It is a 0 to 400 metre tool, tuned to manage how the 03 shifts weight the instant first gear takes drive, so the tyres that actually move the car are doing the work rather than scrabbling.

What this coilover does for your 2018-2026 Lynk & Co領克 03

On a standard 03 the launch wastes energy as wheelspin and squat in the wrong place. This coilover is set to drive load toward the driven wheels at the moment of launch, pressing those tyres harder into the tarmac so they bite instead of scrabble. The result is less idle wheelspin off the line, a more planted front end as the revs climb, and steadier behaviour at the top of the run where a soft road damper would feel vague. For an owner chasing consistent 60-foot and trap times in a 2018-2026 Lynk & Co領克 03, that means repeatable launches instead of one good pass in five.

About the Drag Racing coilover

XYZ Racing builds the Drag Racing coilover specifically for straight-line 0 to 400 metre work, and the same kit logic covers front-, rear- and four-wheel-drive cars. The core idea is launch weight management: the spring and damping setup lets the car move load between the front and rear axles during that first violent instant of drive, forcing the driven tyres into greater compression. More compression means a larger contact patch under load, which cuts the dead time when a wheel is spinning rather than driving. It also holds the car stable as speed builds, where an unsettled chassis bleeds both time and confidence. This is a focused, single-discipline coilover – everything about it serves the launch and the run, not ride comfort or apex precision.

Fitment for the Lynk & Co領克 03 (2018-2026)

This kit is cut for the Lynk & Co領克 03, chassis code LY01, across the 2018 to 2026 model span. It fits the CMA-platform 03 as supplied – check your build year against that range before configuring your spec.

What buyers also search for

• Lynk & Co領克 03 drag coilover for 0 to 400 metre launches
• Lynk & Co領克 03 suspension setup for repeatable 60-foot times
• Drag Racing coilover with launch tuning for FWD, RWD and 4WD cars
• Lynk & Co領克 03 LY01 coilover for quarter-mile traction
• Launch-focused coilover for the 2018-2026 Lynk & Co領克 03

Set your spring and damping options for the Lynk & Co領克 03 and configure yours below.