XYZ Racing Street Advanced Coilovers — Mitsubishi OUTLANDER 2WD/4WD 2003-2006

The first-generation Outlander was built on the same underpinnings as the contemporary Lancer, but Mitsubishi calibrated it upward – taller, softer, and shaped for crossover sensibility rather than the handling precision that platform can genuinely deliver. The 2003-2006 MT33 in either drivetrain form carries that factory compromise in its ride height and damper tune; the XYZ Racing Street Advanced coilover kit is what owners reach for when they want to close the gap between what the chassis is capable of and what the original specification chose to exploit.

Both 2WD and 4WD variants are covered in a single kit, giving Mitsubishi Outlander owners a clear route to improved road dynamics without the fixed-damper compromise of a conventional drop spring.

What this coilover does for your 2003-2006 Mitsubishi Outlander 2WD/4WD

The MT33’s tall factory stance – a sensible crossover calibration in 2003 – translates into body roll through faster road bends that the original spring and damper settings were never tuned to resist. Lowering the centre of gravity addresses this directly, with the gain felt more immediately on the 4WD variant, where the additional mass of the rear coupling system compounds the body’s inherent tendency to lean mid-corner. The 720-way damping adjustment range is broad enough to run a genuinely softened setup for motorway and A-road daily use, then firm incrementally for a track day without any workshop return in between. On the 2WD Outlander, where overall weight is more manageable, a mid-range damping position typically holds the best balance between UK road compliance and controlled body movement through bends.

About the Street Advanced coilover

XYZ’s Street Advanced is the label’s most widely fitted coilover line – developed progressively over years by XYZ’s in-house engineering team and validated in competition conditions on the international stage before the specification reached road sale. The 720 damping adjustment positions give owners a broader tuning envelope than most coilovers in this category offer: there is real scope to vary the ride character to suit road or circuit rather than committing to a single fixed setting. The Street Advanced is mapped specifically for road use and track day work rather than sustained circuit racing, which means the base calibration is already composed and usable from the moment of installation, with the wider ends of the adjustment range held in reserve when conditions demand more. That competition-development background is reflected in the consistency of the damper feel across the full adjustment range, not just at the firm end.

Fitment for the Mitsubishi Outlander 2WD/4WD (2003-2006)

This kit is built for the MT33-chassis Mitsubishi Outlander across the full 2003-2006 production span, covering both drivetrain configurations – 2WD and 4WD – in a single fitment. The specification applies to the first-generation model only; the later Outlander introduced revised suspension geometry from 2006/2007 onward and requires a separate kit.

What buyers also search for

• Mitsubishi Outlander MT33 suspension upgrade for reduced body roll and a lower road stance
• XYZ Racing Street Advanced coilover for the 2003-2006 Outlander 2WD with 720-way adjustable damping
• First-generation Mitsubishi Outlander 4WD coilover kit suited to track day use alongside everyday road driving
• Mitsubishi Outlander 2003-2006 coilover option covering both 2WD and 4WD variants on the MT33 chassis

The Street Advanced fits the MT33 Outlander in 2WD and 4WD forms across the full production run – configure yours below to confirm the specification for your car.