XYZ Racing Drift Spec Coilovers — Subaru FORESTER SH 4WD 2007-2012

The Forester SH’s raised ride height and permanent 4WD drivetrain make it an unlikely drift platform on paper, but that height and the SH’s willingness to shift weight through its long-travel suspension is exactly what a committed drift build exploits. XYZ Racing’s Drift Spec coilover is built around that transfer, not against it, giving the car a controllable pendulum instead of an unpredictable one.

For a Forester SH being built to slide rather than corner flat, damping and ride height need to work together to hold a locked angle through a full pass, not just the entry. This kit is set up so lowering the car doesn’t come at the cost of the wheel travel a 4WD drift car actually needs when the diff is loading up mid-transition.

What this coilover does for your 2007-2012 Subaru Forester SH 4WD

Drop the SH’s ride height correctly and you change how the body loads the outside tyre the instant you initiate – the lower the centre of gravity, the more predictable that initial weight transfer becomes, which matters when you’re trying to catch the same angle every run. The proper bump stroke this kit is set up around means the chassis stays composed once it’s lowered, rather than crashing into its own bump stops mid-slide. On a 4WD platform like the SH, where all four corners are doing work simultaneously, stable body control through the turn-in phase is what lets you hold an angle instead of chasing it. The result on your Forester is a car that transitions predictably, settles into an angle rather than snapping into one, and gives you a consistent baseline to adjust from run to run.

About the Drift Spec coilover

The Drift Spec is engineered specifically around drift competition use rather than adapted from a road or track-day design. Its construction is built to stabilise the vehicle body during high-speed turning so the car settles into a clean, controllable angle instead of fighting the driver for it – a distinction that matters once you’re committed mid-slide and need the chassis to behave rather than surprise you. Getting the ride height down correctly, with the bump stroke set up as intended, is central to how this kit works: it’s what lets the car hold that controlled angle rather than losing composure as load shifts through the corner. On the Forester SH, that translates into a chassis that manages its own weight transfer instead of relying purely on driver correction, sharpening the margin between a clean slide and a spin.

Fitment for the Subaru Forester SH 4WD (2007-2012)

This kit is built for the Subaru Forester SH chassis in 4WD configuration across the 2007-2012 production run. Confirm your Forester matches the SH generation before ordering, as suspension geometry changes between Forester generations mean earlier and later chassis codes are not interchangeable with this spec.

What buyers also search for

• Subaru Forester SH drift suspension setup for competitive angle control
• Subaru Forester SH 4WD coilovers built for lowered ride height without losing bump travel
• Forester SH Drift Spec damping for repeatable slide entry and transition
• Subaru Forester coilover kit for 4WD drift builds 2007-2012

Spec the Drift Spec coilover for your Forester SH and configure yours below.