XYZ Racing Pro Rally Coilovers — Toyota WISH (TYPE 2) 2009-2017

The ZGE20 WISH was never intended for gravel stages – Toyota built the second-generation platform as a compact people carrier, tall-bodied and comfort-oriented, with a centre of gravity that sits well above what any rally engineer would want from a competition car. Yet the WISH has earned a legitimate place in production-based rally categories across Asian championships, and it brings a genuine challenge: managing the body motion of an MPV-sized chassis on loose, unpredictable surfaces.

The XYZ Racing Pro Rally coilover for the Toyota WISH (Type 2) addresses that challenge directly. Designed for gravel and snow competition, this kit replaces the factory suspension with hardware that treats the WISH as the competitive vehicle it already is for a committed driver.

What this coilover does for your 2009-2017 Toyota WISH (TYPE 2)

The WISH’s tall architecture concentrates mass higher than any equivalent hatchback, which amplifies body roll and makes the factory setup slow to respond to direction changes on gravel. Rally-specification coilovers tighten that response considerably – the car sits with defined weight transfer under cornering loads rather than pitching through the soft compliance Toyota built in for passenger comfort. On snow surfaces, where throttle-on understeer from the front-wheel-drive platform is a constant management task, shorter suspension travel and firmer spring rates hold the chassis flatter and give the driver more predictable front-end loading mid-corner.

About the Pro Rally coilover

The XYZ Racing Pro Rally system is built specifically for gravel and snow stages, and it exists in two distinct configurations to suit different levels of competitive build. The first installs directly to the standard WISH bodyshell without structural modification – the appropriate choice for production-class regulations where body alteration is prohibited, or for drivers taking a serious step forward in capability without committing to a full competition build. The second type assumes the car body has already been modified for motorsport installation; it is the professional configuration, designed for outright-class rally programmes where bodyshell changes are permitted and geometry can be developed beyond what a stock mounting arrangement allows. Both variants share the same core intent: proper rally hardware engineered for loose surfaces, not a road coilover with revised marketing.

Fitment for the Toyota WISH (TYPE 2) (2009-2017)

The kit carries chassis reference TO61-1, covering the second-generation Toyota WISH across the ZGE20 series in FWD configuration, from the 2009 model year through to the close of production in 2017. If your car has already had suspension height or mounting points altered as part of a prior build, verify compatibility through the configurator before purchasing.

What buyers also search for

• Toyota WISH Type 2 suspension upgrade for rally and stage competition
• ZGE20 WISH coilover kit for gravel and snow-surface events
• Toyota WISH 2009-2017 rally coilovers for production-class motorsport categories
• WISH Type 2 suspension replacement for Asian rally championship builds
• Toyota WISH coilover system to address MPV body roll in competition use

Two installation variants are available for the Pro Rally – direct-fit for production-class regulations, or full professional spec for modified bodyshells. Pick your variant and configure yours below.