Porsche 991 CARRERA-2/S/TURBO (without hydraulic lift system) (Cancellation Kit for Electronic Damping) 2011-2019 — Coilovers

The 991-generation 911 carries its flat-six behind the rear axle, and from the factory most Carrera 2, S and Turbo cars rode on PASM electronic dampers that managed that rearward mass through software rather than valving you could touch. This XYZ Racing coilover kit for the Porsche 991 Carrera 2/S/Turbo (2011-2019) replaces that closed system with height-adjustable, mechanically adjustable struts you can actually set up yourself – and because it ships with the cancellation kit for electronic damping, it emulates the original PASM circuit so the dash stays quiet and no suspension fault lights appear after install.

This is the fitment for cars built without the hydraulic lift system, so it is aimed at owners running a fixed, lower ride height rather than a nose-lift setup. Choose the type that matches how you use the car: Street Advanced and Super Sport for fast road, Top Sport and Circuit Master for track work, Racing Spec for a committed circuit build, and the Drift, Tarmac Rally, Gravel Rally and Pro Rally specs for their named disciplines.

What this coilover system does for your 2011-2019 Porsche 991 Carrera 2/S/Turbo

Swapping the PASM struts for a mechanical coilover gives you direct control over corner balance and rake on a chassis that lives or dies by how its rear axle is loaded. Wind in some front ride height and the 991’s tendency to run wide on turn-in softens; set the rear correctly and you keep traction biting out of slow corners without the tail going light over crests. The independent ride-height and damping adjustment lets you separate stance from spring behaviour, so the car can sit purposefully without crashing over UK B-road ridges. On track, consistent monotube damping holds the body flat through fast direction changes where the standard adaptive setup would otherwise be guessing. The bundled electronic damping cancellation kit means none of this comes at the cost of a permanent dashboard warning.

About the XYZ Racing coilover range

XYZ Racing builds these kits around a height-adjustable lower mount and damper-adjustable struts, letting you set ride height and damping force as separate jobs rather than one compromise. The range spans nine named specs so the same 991 platform can be configured for road comfort, repeat track sessions, drift angle or loose-surface rally use, each with spring rates and valving chosen for that discipline. Construction centres on a serviceable strut body that can be rebuilt and revalved rather than binned when worn. Critically for this 991 application, the kit integrates the cancellation module for the factory electronic damping, so the original PASM wiring is satisfied and the car reads the new passive setup without throwing codes. The result is a mechanically honest suspension you tune with spanners, not menus.

Fitment for the Porsche 991 Carrera 2/S/Turbo (2011-2019)

This kit fits the 991 chassis (PO31-C) across Carrera 2, Carrera S and Turbo variants built 2011 to 2019, specifically cars optioned without the hydraulic front lift system. The included cancellation kit handles the electronic damping conversion. Confirm your car runs the standard (non-lift) front end before ordering.

What buyers also search for

• Porsche 991 coilover conversion with PASM electronic damping cancellation kit
• 991 Carrera S suspension upgrade for road and track without dashboard fault codes
• Porsche 911 991 height-adjustable coilovers for cars without hydraulic lift
• 991 Turbo coilover kit options across fast-road and circuit specifications
• Porsche 991 Carrera 2 ride height and damping adjustment for UK roads

Pick the spec that suits your 991 and configure yours below.