XYZ Racing Pro Rally Coilovers — Peugeot 306 1993-2002

The 306’s torsion-beam rear and sweet, talkative front end made it one of the great budget rally weapons of the 1990s, and it is exactly that chassis the XYZ Racing Pro Rally coilover is built to exploit. This is loose-surface hardware – a gravel and snow setup aimed at top-flight rally competition, not a fast-road lowering kit pressed into stage duty.

On a PE06 306, the priorities are wheel travel, damping that survives repeated big hits, and a front end that still rotates predictably when you lift mid-corner. The Pro Rally kit is specified around those demands rather than ride height and stance.

What these coilovers do for your 1993-2002 Peugeot 306

Fit the Pro Rally coilovers and the first thing you notice on a rough stage is composure: the damping soaks up corrugations and landing impacts without packing down or going hot and vague. The longer-travel rally valving keeps the front tyres loaded over crests and through ruts, so the 306’s natural agility translates into grip instead of skipping. Turn-in stays sharp, and the car’s trademark lift-off rotation becomes something you can place on the throttle rather than fight. For a front-driven 306 on gravel or snow, that means more confidence to carry speed into a corner and get back to power earlier on exit.

About the Pro Rally coilover

The Pro Rally is a competition gravel and snow suspension, and XYZ Racing supplies it in two distinct specifications depending on how far you are willing to go with the car. The first is an amateur-level setup that bolts directly to the original 306 chassis, retaining the standard mounting points for a straightforward installation on a road-registered or clubman rally car. The second is a full professional specification intended to be fitted after the bodyshell has been modified, freeing up travel and geometry for serious stage use. Both share the same loose-surface design intent – generous suspension travel and damping tuned for the impacts and surface changes of gravel and snow rather than smooth tarmac. Choosing between them comes down to whether you are running a near-standard shell or a properly prepared competition car.

Fitment for the Peugeot 306 (1993-2002)

This kit is specified for the Peugeot 306, chassis code PE06, across the full 1993 to 2002 production run. Confirm whether you need the direct-fit amateur specification for an unmodified chassis or the professional specification for a body-modified competition car before ordering.

What buyers also search for

• Peugeot 306 rally coilovers for gravel and snow stages
• Peugeot 306 PE06 competition suspension with long-travel damping
• Direct-fit 306 coilovers for a standard chassis versus modified-body spec
• Peugeot 306 loose-surface suspension upgrade for clubman and pro rally
• XYZ Racing Pro Rally coilover options for the 1993-2002 306

Decide which specification matches your 306 build and configure yours below.