XYZ Racing Pro Rally Coilovers — Mitsubishi ECLIPSE 2000-2006

The third-generation Eclipse was built as a front-drive grand tourer: nose-heavy, softly sprung, with most of its mass sitting over the driven front axle. That layout is exactly what a loose-surface rally setup has to fight – weight transfer that wants to wash the front wide on turn-in, and a body that pitches under braking on broken ground. The XYZ Racing Pro Rally coilover for the Mitsubishi Eclipse exists to take that road-biased chassis and give it the travel, damping control and adjustable ride height a car needs on gravel and snow stages.

This is not a fast-road lowering kit. Pro Rally sits at the competition end of the range, built for top-flight rally use where the surface is loose, the impacts are repeated, and the suspension has to stay composed over jumps and ruts rather than over kerbs.

What this coilover kit does for your 2000-2006 Mitsubishi Eclipse

Fitted to a 2000-2006 Mitsubishi Eclipse, the Pro Rally kit changes how the car behaves the moment the tarmac runs out. More usable travel keeps the front tyres loaded over crests and compressions instead of skipping, so the nose-heavy Eclipse turns in on gravel rather than ploughing on. Rally-specific valving controls the body pitch that the standard GT dampers allow, steadying the car under braking into loose corners and on landing. Adjustable ride height lets you set the car for the surface – higher for rough gravel, lower for graded snow tracks – and recover geometry the standard struts were never configured to deliver. The result is a front end you can lean on and a rear that stays planted as weight shifts across the axle.

About the Pro Rally coilover

Pro Rally is XYZ Racing’s loose-surface competition suspension, designed specifically for gravel and snow rallying rather than circuit or road use. XYZ offers it in two distinct fitment paths. The first is an amateur specification that bolts straight to the original Eclipse chassis with no cutting or fabrication, which is the practical route for club-level and privateer crews running a near-standard shell. The second is a professional specification intended to be fitted after the body has been modified to accept it, freeing up the extra travel and strut packaging a full competition build demands. Both share the same loose-surface intent – long travel, durable damping and the ability to soak up repeated heavy hits – but the professional route trades a more involved install for the geometry a serious stage car needs.

Fitment for the Mitsubishi Eclipse (2000-2006)

This kit is built for the Mitsubishi Eclipse, chassis code MT15, covering the 2000 to 2006 model years. Confirm your car falls inside that year span before ordering, and choose between the amateur direct-fit specification and the professional post-modification specification depending on how far your build has gone.

What buyers also search for

• Mitsubishi Eclipse gravel rally coilover kit for loose-surface stages
• Mitsubishi Eclipse 2000-2006 rally suspension with adjustable ride height
• Pro Rally coilover for snow and gravel competition use
• Front-drive Eclipse rally damping that survives repeated heavy impacts
• Mitsubishi Eclipse coilover options for club-level and professional rally builds

Set your surface, pick your amateur or professional specification, and configure your Pro Rally kit below.