XYZ Racing Drag Racing Coilovers — Maserati MC20 (with hydraulic lift, excl.control system) 2020-2026

The MC20’s mid-engined, rear-drive layout sits its mass low and behind the driver, loading the Nettuno V6’s driven axle – a starting point most cars chasing a quarter-mile would envy. The XYZ Racing Drag Racing coilover for the Maserati MC20 is built to exploit exactly that, governing how the chassis feeds load into its rear tyres in the first few metres off the line.

This is a launch-focused setup, not a circuit compromise. It is tuned to manage standing-start weight transfer so the rear contact patches hook up instead of lighting up, on a carbon-tubbed car that already carries its weight rearward.

What this coilover does for your 2020-2026 Maserati MC20

Off the line, the difference is in how the MC20 plants its rear axle. The damping is set to control squat and shift load toward the driven wheels at the moment of launch, pressing the rear tyres into the tarmac rather than letting them break traction and idle. That means less wasted wheelspin in the critical opening metres, a cleaner conversion of the V6’s torque into forward drive, and steadier behaviour as the car gathers speed down the strip. For a 600bhp-plus rear-driver, traction off the line is the single biggest variable in a clean run, and this kit exists to make that repeatable.

About the Drag Racing coilover

XYZ Racing’s Drag Racing series is engineered specifically for 0-400 metre standing-start work, with settings developed across front-, rear- and four-wheel-drive applications. The core idea is dynamic weight management: the suspension is configured to alter front-to-rear load distribution during the launch according to which axle is driven, forcing greater compression into the driven tyre. The result is reduced wheel idle and spin at the hit, with stability held as the car accelerates toward terminal speed. On the rear-drive MC20 that logic concentrates on planting the rear, where every bit of available grip is needed early.

Fitment for the Maserati MC20 (2020-2026)

This kit is specified for the MS06-chassis Maserati MC20 across the 2020-2026 model span, in the variant fitted with the factory hydraulic nose-lift hardware (control system excluded). Confirm your car carries the hydraulic lift before ordering so the front fitment matches.

What buyers also search for

• Maserati MC20 drag racing coilovers for quarter-mile launches
• MS06 MC20 suspension that plants the rear axle off the line
• Maserati MC20 standing-start traction upgrade for high-power runs
• Drag-focused coilover kit for the 2020-2026 MC20 with hydraulic lift

Set your launch-day spec for the MC20 and configure yours below.