XYZ Racing Drag Racing Coilovers — Ford KA 2008-2014

Drag racing a Ford KA is a problem of traction, not power. The second-generation KA (FO10) carries barely over a tonne on a short wheelbase, and the instant you drop the clutch the nose unloads and the front tyres scrabble for grip they were never given from the factory. This is a featherweight front-driver, and everything that happens in the first sixty feet decides the run. The XYZ Racing Drag Racing coilover is built for exactly that moment – the 0-400 metre launch – rather than for cornering or fast-road comfort.

It is a single-purpose setup. The spring and damper strategy is chosen to control how weight shifts off the line so the driven front wheels stay planted, killing the wheelspin that bleeds time before the KA has even cleared first gear.

What this coilover set does for your 2008-2014 Ford KA

After fitting, the difference shows up at the line. The damping holds the front of the KA loaded as you launch, so the driven tyres bite instead of lighting up, and that reduces the dead time the wheels spend spinning rather than driving the car forward. Down the strip, the stiffer, controlled platform keeps the light KA settled at speed where a soft factory setup would float and wander. You also get ride-height adjustment to set rake and corner weights for a consistent, repeatable launch every pass.

About the Drag Racing coilover

XYZ Racing builds this coilover specifically for straight-line 0-400 work, and the same design logic covers front-, rear- and four-wheel-drive applications. The core idea is weight management: the setting shifts load toward the driven wheels during the launch, forcing the driving tyre into greater compression so it digs in harder. That extra compression cuts the idle time of the wheel – the fraction of a second it spins without traction – and steadies the car as speed builds toward the top end. On a front-drive KA, that means the front axle stays loaded when it matters most and the platform stays composed at the far end of the run.

Fitment for the Ford KA (2008-2014)

This kit is matched to the FO10-chassis Ford KA across the 2008 to 2014 model years. Confirm your chassis code and registration year against the listing before ordering, and check your build against the configurator options below.

What buyers also search for

• Ford KA drag coilovers for hard 0-400 metre launches
• Ford KA front-wheel-drive traction setup for the strip
• Ford KA FO10 adjustable ride height for corner weights and rake
• XYZ Racing Drag Racing coilovers for a lightweight Ford launch car
• Ford KA 2008-2014 suspension built for straight-line consistency

Set your spec and launch height for the FO10 KA in the configurator below.