XYZ Racing Drag Racing Coilovers — Hyundai TIBURON 1996-2001

Launching a front-wheel-drive Tiburon hard is a fight against the car’s own weight transfer. Drop the clutch and mass pitches rearward, lifting the driven front tyres at the exact moment you need them buried into the tarmac. The XYZ Racing Drag Racing coilover for the Hyundai Tiburon 1996-2001 exists to manage that pitch on purpose, instead of leaving it to soft factory dampers that let the nose float.

This is a 0 to 400 metre tool, not a fast-road set-up wearing a stripe. The damping and ride-height control are built to keep the front contact patch loaded off the line and to hold the HY22 chassis steady as it piles on speed toward the traps.

What these coilovers do for your 1996-2001 Hyundai Tiburon

The gain you feel first is bite. By controlling how the Tiburon shifts load front-to-rear under hard acceleration, these coilovers force the driven front tyres into greater compression as you launch, which cuts the idle wheelspin that bleeds away your sixty-foot time. Adjustable ride height lets you set a deliberate nose-down rake or sort corner weights to suit your launch technique and tyre. As the car comes onto the bumper-stops near the top of a run, the firmer control keeps it tracking straight rather than wandering, so the high-speed end of the strip stays composed. For a light front-drive coupe like the Tiburon, that consistency at the line is where the time is found.

About the Drag Racing coilover

The Drag Racing series is built specifically for 0 to 400 metre work and is offered across front-, rear- and four-wheel-drive platforms, so the application logic suits the Tiburon’s FWD layout directly. The core idea is managed weight transfer: the set-up shifts load between the front and rear axle according to which wheels are driven during instant, full-throttle acceleration. That forces the driving tyre into harder compression at the contact patch, reducing the wheel’s idle spin and getting the car hooked sooner. The same control that helps it leave the line also steadies the chassis at high speed, so the top end of a run is more predictable. It is a focused, single-purpose coilover rather than a do-everything kit.

Fitment for the Hyundai Tiburon (1996-2001)

This kit is matched to the Hyundai Tiburon, HY22 chassis, across the 1996 to 2001 year span. Confirm your build year falls inside that range before ordering. Only the fitment facts listed here apply; check your exact specification below.

What buyers also search for

• Hyundai Tiburon drag coilovers for quicker sixty-foot times
• HY22 Tiburon suspension set-up for 0 to 400 metre launches
• Front-wheel-drive Tiburon coilovers that plant the driven tyres
• Adjustable ride-height coilovers for a 1996-2001 Tiburon strip car
• Hyundai Tiburon drag suspension for high-speed stability through the traps

Pick your ride height and spec for the Tiburon and configure yours below.