XYZ Racing Drag Racing Coilovers — Honda CITY GM2/GM3 2007-2013

Getting a light front-drive saloon like the GM2/GM3 City off the line cleanly is a traction problem long before it is a power problem. The front tyres have to take the launch load and the torque at the same instant, and a soft factory damper lets the nose lift and the contact patch go light exactly when you need it planted. The XYZ Racing Drag Racing coilover for the Honda City GM2/GM3 is built to fix that specific moment.

It is a launch-focused setup, not a fast-road compromise. Spring and damper rates are chosen to control weight transfer through the first few metres of a 0-400 run, so the driven front wheels stay loaded and hooked rather than spinning the revs away.

What this coilover does for your 2007-2013 Honda City GM2/GM3

On a car this light, ride height and corner balance change the whole launch. Lowering the City onto a coilover platform and setting cross-weight lets you bias static load over the front axle so the drive tyres bite as the clutch comes home. Adjustable damping gives you control over how quickly the nose settles after the hit, which on a torsion-beam rear axle is the difference between a clean leave and a bog or a smoky, slow one. The height adjustment also lets you fine-tune rake to suit your tyre and surface. For street driving back from the strip you keep a consistent, repeatable platform rather than blown-out original dampers.

About the Drag Racing coilover

This series is engineered specifically for 0-400 drag use and is offered across front-drive, rear-drive and four-wheel-drive applications, so the same design logic carries whatever lays the power down. The damping and spring strategy is set up to shift front-to-rear weight in the instant the car launches, throwing load onto the driven wheels so the drive tyres see greater compression and a bigger contact patch off the line. That extra loading cuts the dead time where the wheels spin without driving the car forward, getting you hooked up sooner. The setup is also tuned to keep the car stable as speed builds down the strip, so the gains at launch are not given back through the traps.

Fitment for the Honda City GM2/GM3 (2007-2013)

This kit is matched to the GM2/GM3 City, chassis code HN26, covering the 2007 to 2013 model years. It is a front-wheel-drive application, so the launch tuning works the front axle. Confirm your chassis code and year against the listing before you order.

What buyers also search for

• Honda City GM2/GM3 drag coilovers for quarter-mile and 0-400 launches
• Front-wheel-drive City suspension that plants the drive tyres off the line
• HN26 City 2007-2013 height and corner-balance adjustment for the strip
• Launch-focused coilover kit for a light Honda saloon

Set your height, rake and damping to suit your tyre and surface, and configure yours below.