XYZ Racing Tarmac Rally Coilovers — Peugeot 1007 2005-2009

The 1007 is an unusual tarmac stage entrant, but then the most interesting club-rally builds rarely start with the obvious car. PSA’s compact platform, the distinctive sliding-door bodywork adding mass over the front axle, and a FWD drivetrain that lives or dies by front-axle traction: these are the specific conditions the XYZ Racing Tarmac Rally coilover is designed to operate in. Short wheelbases amplify crest-to-crest chassis movement, and a suspension that can’t absorb impact quickly will have a 1007 skipping wide across broken tarmac before the driver has time to correct.

The Tarmac Rally kit solves that by drawing directly on XYZ’s sealed-stage competition programme – the damper settings are the product of actual tarmac running, not a desk calculation. For a FWD car where momentum through slow corners is everything, the ability to keep rubber on the road surface on the way into and out of each corner matters more than peak spring stiffness.

What this coilover does for your 2005-2009 Peugeot 1007

On the 1007, the Tarmac Rally coilover provides genuine compliance over the sharp-edged road breaks and stage compressions that would otherwise unsettle the chassis. Tyre traction holds up because the suspension follows undulations in the surface rather than deflecting off them – on a front-wheel-drive layout, that translates directly into drive exiting hairpins and slow corners. Impact energy that would otherwise transfer into the bodyshell is absorbed at the damper instead, keeping the car stable where uneven pavement tries to redirect the nose. The result is a front axle that remains predictable under hard braking and through direction changes across a full day’s running.

About the Tarmac Rally coilover

The Tarmac Rally series is engineered around the demands of sealed-surface competition, where stage surfaces degrade through the course of a day and a suspension must perform consistently from first to last. All settings in the range come from XYZ’s active tarmac rally competition experience – this is not a re-valved road kit but a specification developed through competitive use. The design priorities are progressive impact absorption on broken and undulating tarmac, control of bodyshell movement under hard direction changes, and the consistent tyre-to-road contact that FWD competitors depend on. Construction and tuning choices across the range reflect that competition foundation throughout.

Fitment for the Peugeot 1007 (2005-2009)

This kit covers the Peugeot 1007 on chassis code PE03 across the full production run from 2005 to 2009. Fitment is specific to the PE03 platform – confirm your year and variant against that chassis designation before ordering.

What buyers also search for

• Peugeot 1007 coilover kit for tarmac rally and club-stage competition
• Peugeot 1007 suspension upgrade for sealed-surface FWD handling
• XYZ Racing Tarmac Rally coilover for compact PSA-platform cars
• Peugeot 1007 2005-2009 damper upgrade for bump absorption and front-axle traction

This kit is available to configure in the spec selector below – build yours below.