XYZ Racing Drag Racing Coilovers — Scion XA 2004-2006

On a front-drive launch the Scion XA lives or dies by what its front tyres do in the first car length, and the standard car was tuned for supermarket runs, not a staging beam. The XYZ Racing Drag Racing coilover takes that soft, tall economy-hatch suspension and gives you control over how the XA loads its driven wheels the instant you leave the line.

This is the drag-specific spec in the XYZ Racing range, built around 0-400 metre launches rather than corner balance or fast-road compliance. It governs how weight shifts between the front and rear axles when you side-step the clutch, so the engine’s modest output reaches the tarmac as forward drive instead of bleeding away as wheelspin from the inside front wheel.

What this coilover does for your 2004-2006 Scion XA

The first thing you feel in the XA is a cleaner launch: less of that first move wasted spinning a lightly loaded front tyre, more of it turning into trap speed. Height adjustment lets you drop the car to lower its centre of gravity and set a rake that helps plant the front axle as the nose lifts under hard acceleration. Because the platform is so light to begin with, getting the geometry and weight transfer right matters more here than chasing spring rate, and a set of dedicated coilovers gives you the corner-by-corner adjustment to find a repeatable, consistent sixty-foot time down the strip.

About the Drag Racing coilover

This is XYZ Racing’s straight-line spec, developed specifically for 0-400 metre drag use across front-, rear- and four-wheel-drive cars. The core idea is managing how the chassis redistributes weight between the front and rear during a launch, forcing greater compression onto the driving tyres so they bite rather than break traction. By cutting the idle moment where the drive wheels spin before they hook, it shortens the time lost off the line and keeps the car settled and stable as the speed climbs through the higher gears. The height-adjustable construction lets you tune ride height, rake and preload to suit your tyre, gearing and surface.

Fitment for the Scion XA (2004-2006)

This kit is matched to the Scion XA, chassis code SC02, covering the full 2004 to 2006 model run. It is the drag-oriented spec in the XYZ Racing coilover line for this platform.

What buyers also search for

• Scion XA coilovers for FWD drag racing and quarter-mile launches
• SC02 chassis suspension setup focused on front-wheel traction off the line
• 2004-2006 Scion XA height-adjustable coilovers for a lower drag stance
• XYZ Racing Drag Racing spec for repeatable sixty-foot times

Pick your ride height and spec for the Scion XA below and configure your kit.