XYZ Racing · Made-to-order · UK shipping

Peugeot 3008 2008-2016 — Coilovers

The first-generation Peugeot 3008 carries its weight high and soft. Built on PSA’s PF2 platform with a nose-heavy front-drive layout and damping tuned for school-run comfort, it leans early and settles slowly through a corner. A set of XYZ Racing coilovers for the Peugeot 3008 attacks exactly that: lower the body, control the roll, and turn a tall family crossover into something that changes direction with intent.

This listing is the gateway to the full XYZ Racing coilover range for the 2008-2016 3008 (chassis PE18). Whatever balance you want between a planted fast-road drop and a stiffer, track-focused setup, you pick the series here and configure the exact spec below.

What this coilover does for your 2008-2016 Peugeot 3008

Height adjustment lets you drop the 3008’s centre of gravity, which is the single biggest lever on a tall crossover for cutting body roll and sharpening turn-in. Independent ride-height setting means you can level the stance front to rear rather than leaving the factory nose-up rake. On the firmer series, the tighter damping stops the front axle from washing into understeer when you load it up, so the car holds a line instead of running wide. The everyday payoff is a 3008 that feels tied down at motorway speeds and far less floaty over crests and roundabouts, without battering you on broken UK B-roads if you choose a road-biased series.

About the coilover range

The Peugeot 3008 coilover range spans six XYZ Racing series, each built around the same threaded-body, height-adjustable architecture but valved for a different job. Super Sport is the fast-road choice, trading a measured drop and improved body control for daily usability. Top Sport steps up to track-day duty with firmer rates. Racing Spec, Circuit Master, Tarmac Rally and Drift Spec push further into dedicated circuit, rally and drift territory, with stiffer damping and setups aimed at competition use rather than the commute. All share full ride-height adjustment so you can dial the stance and corner balance to suit how the 3008 is actually driven.

Fitment for the Peugeot 3008 (2008-2016)

These coilovers are matched to the first-generation Peugeot 3008, chassis code PE18, covering the 2008 to 2016 model years. Confirm your build year falls inside that span before configuring, then choose your series and spec below.