XYZ Racing Drag Racing Coilovers — Toyota VIOS XP90 TYPE 2 (Front top mount w/o bolts) 2007-2013

Launch the XP90 VIOS hard off the line and the stock suspension immediately works against you: weight transfers rearward, the front driven tyres unload, and grip that could translate into elapsed time evaporates in wheel spin before you’ve cleared the start line. These XYZ Racing Drag Racing coilovers for the Toyota VIOS XP90 TYPE 2 (2007-2013) address that core FWD challenge directly, with a geometry and spring brief oriented around the 0-400m strip rather than any road or circuit compromise.

The TYPE 2 fitment uses the front top mount without bolts – a configuration specific to this XP90 variant and distinct from other mounting arrangements in the VIOS range.

What this coilover does for your 2007-2013 Toyota VIOS XP90 TYPE 2

The critical number in FWD drag is the 60-foot time, and it hinges on keeping the driven front wheels loaded at the moment of launch. These coilovers are built to shift the front-to-rear weight bias in response to the driven axle’s demands – forcing greater compression through the front contact patches at peak acceleration rather than letting inertia strip them of load. That reduction in wheel spin translates directly into tighter 60-foot figures and more consistent runs down the strip, with the geometry also aiding stability as the XP90 builds speed toward the far end of the straight.

About the Drag Racing coilover

XYZ Racing developed this series specifically for 0-400m competition, with a design brief broad enough to cover FWD, RWD, and 4WD cars – the VIOS XP90 being an established platform in the Asian drag scene as a light, front-driven saloon with a devoted builder following. The setup philosophy centres on instant weight redistribution: by adjusting front and rear load in response to which axle is transmitting drive, the system compresses the driven tyres harder under launch conditions. This reduces the dead time between the lights going green and the tyres finding full drive, then maintains composure as the car pulls to maximum speed. Construction and tuning intent are squarely aimed at the repeatable demands of the strip rather than the broader operating window of a road or circuit part.

Fitment for the Toyota VIOS XP90 TYPE 2 (2007-2013)

Built to chassis code TO58, this set covers the Toyota VIOS XP90 in the specific TYPE 2 configuration with front top mount without bolts. Year coverage runs from 2007 to 2013. The TYPE 2 mounting arrangement is distinct from other XP90 variants, so confirm your front strut configuration before ordering.

What buyers also search for

• Toyota VIOS XP90 coilover upgrade for 0-400m drag strip use
• VIOS XP90 TYPE 2 front suspension setup for FWD drag racing
• Toyota VIOS 2007-2013 coilovers for launch traction and 60-foot consistency
• XP90 VIOS drag coilover with front top mount without bolts fitment
• XYZ Racing drag-spec coilover for Toyota XP90 competition builds

Select your configuration and build yours below.