XYZ Racing Pro Racing Gravel/Snow Coilovers — Toyota AVALON XLS (TYPE 2) 1994-1999

The first-generation Toyota Avalon XLS sits at an unlikely intersection: a stretched, comfort-tuned FWD platform with a 3.0-litre V6 sitting heavily over the front wheels, pressed into gravel stage or snow-rally duty. Factory suspension on the TO06 chassis was calibrated for quiet motorway travel – soft rates, conservative travel limits, damping tuned to iron out ordinary road imperfections rather than absorb the repeated, asymmetric hits of a gravel stage at speed.

Taking an Avalon XLS into competitive rally or rallycross means rethinking the suspension from first principles. The nose-heavy FWD layout amplifies the challenge: front axle load transfer on rough surfaces punishes undersprung setups quickly, and standard damper oil volumes on a comfort-oriented platform are not sized for the thermal demands of sustained stage use. These XYZ Racing Pro Racing Gravel/Snow coilovers address both.

What this coilover does for your 1994-1999 Toyota AVALON XLS (TYPE 2)

Increased front and rear travel extends the buffer between chassis and compression stop, giving the Avalon’s long wheelbase room to track cleanly over ruts and crests rather than stepping off line when the surface drops away. The enlarged oil and nitrogen gas reservoir resists heat build-up through repeated heavy inputs – a critical factor on gravel, where shock fade compounds through a stage in ways that road-spec dampers were never designed to handle. Three independent adjustment knobs allow you to tune damping response at each end of the car, letting you manage the FWD platform’s natural tendency to load the front axle through rough-surface corners. On loose surfaces, how the nose behaves under that load is where stage runs are made or lost.

About the Pro Racing Gravel/Snow coilover

Developed specifically for rally racing and rallycross, the Pro Racing Gravel/Snow specification extends travel at both front and rear axles to create a greater clearance buffer against rough terrain. The increased suspension oil volume and elevated nitrogen gas charge are the thermal engineering at the core of this product: by expanding the fluid reservoir, the design slows the rate at which shock oil temperature rises during sustained use, preventing the performance degradation that follows when oil thins under heat. The three-knob adjustment system uses a small-orifice passage in the oil circuit; on significant bumps, the oil moving through this restricted passage can produce a faint noise – a known characteristic of the design, not a fault condition. This coilover is intended for circuit and closed-stage competition environments where surface conditions demand a different suspension architecture to the road.

Fitment for the Toyota AVALON XLS (TYPE 2) (1994-1999)

This kit is listed to chassis code TO06, covering the Toyota Avalon XLS (Type 2) between 1994 and 1999. Confirm your car matches the XLS (Type 2) designation before ordering – cross-reference the chassis code against your build documentation to rule out alternative trim configurations within the first-generation Avalon range.

What buyers also search for

• Toyota Avalon 1994-1999 long-travel coilover for gravel and snow stage competition
• TO06 Avalon XLS rally suspension upgrade with extended oil volume
• Toyota Avalon first-generation FWD coilover with three-knob damping adjustment
• XYZ Racing Pro Racing Gravel/Snow heat-resistant suspension for closed-stage use
• Toyota Avalon XLS (Type 2) coilover conversion for rallycross and rough-surface events

The Pro Racing Gravel/Snow is a specific tool for a specific job. If the Avalon is your stage car, pick your spec below.