XYZ Racing Drag Racing Coilovers — BYD F0 2008-2026

The Byd F0 weighs barely more than three-quarters of a tonne and puts everything it has through the front axle, which makes the launch the whole race. Get the nose loaded and the front tyres planted off the line and a light front-driver like the F0 leaves cleanly; fluff the first car-length and you spend the rest of the strip chasing it. The XYZ Racing Drag Racing coilover for the Byd F0 is built around that single moment.

This is not a fast-road or circuit setup pressed into service. The Drag Racing kit is tuned specifically for the 0 to 400 metre run, where what happens in the first metre decides the slip.

What this coilover does for your 2008-2026 Byd F0

On a featherweight front-driver, the limiting factor at launch is how much load you can throw onto the driven tyres before they break traction. This coilover’s damping and ride-height settings are calibrated to shift weight rearward and back onto the nose through the launch sequence, pressing the front contact patches down harder at the moment the clutch comes up. The practical result on your Byd F0 is less wheelspin off the line, more of the engine’s effort turned into forward movement, and a car that settles and tracks straight as the speed builds rather than skating around on a chassis set up for cornering it will never do at the strip.

About the Drag Racing coilover

XYZ Racing designed this coilover for straight-line 0 to 400 work and offers the same philosophy across front, rear and four-wheel-drive platforms, with the damping logic following whichever axle drives the car. The setting deliberately manages front-to-rear weight transfer during the launch so the driven tyres see greater compression at the instant it matters, cutting the dead time the wheels spend spinning rather than gripping. Beyond the launch it is built to keep the car stable as terminal speed rises down the strip. For the front-drive F0, that means the entire calibration works to keep the front tyres loaded and hooked up.

Fitment for the Byd F0 (2008-2026)

This kit is specified for the Byd F0, chassis code BY01, across the 2008 to 2026 production span. Confirm your chassis code and model year against the selector below before ordering so the spring and strut hardware matches your car.

What buyers also search for

• Byd F0 drag racing coilovers for quicker 0 to 400 metre launches
• BY01 suspension setup to reduce front wheelspin off the line
• Byd F0 coilover kit tuned for straight-line weight transfer
• Front-wheel-drive Byd F0 launch and high-speed strip stability

Set your spec for the Byd F0 and configure your Drag Racing coilover below.