XYZ Racing Street Advanced Coilovers — Audi S3 SPORTBACK 8V φ55 (Cancellation Kit for Electronic Damping) 2013-2020

The 8V S3 Sportback runs factory magnetic ride from the factory on this build, and swapping to a fixed-damping coilover means the ECU’s electronic damper signal has nowhere to go. This Street Advanced kit ships with the cancellation kit built in, so the S3’s electronics stay quiet while the coilover takes over ride control completely. It’s a fast-road-to-track-day set-up, not a full race rig – the point is sharper body control for the 2.0 TFSI’s extra weight over the front axle without turning your daily into a chore.

Quattro-equipped S3s carry more nose weight than the front-drive A3 they’re based on, and that mass transfers hard under trail-braking into a corner. Street Advanced gives you the range to firm up compression and rebound enough to keep that transfer in check, while still leaving comfort on the table for motorway miles.

What this coilover does for your 2013-2020 Audi S3 SPORTBACK 8V φ55 (Cancellation Kit for Electronic Damping)

With the cancellation kit resolving the electronic-damper conflict, you get a genuinely usable 720-way damping range to work with rather than a compromise setup fighting the factory ECU. Lower, adjustable ride height cuts body roll through direction changes, which matters on the Sportback’s quattro chassis where weight transfer is already working against you under load. Firming the front end reduces dive under braking, sharpening turn-in response into fast corners without unsettling the rear on the way out. Because damping is independently adjustable, you can run the S3 stiff for a trackday and back it off for the drive home – one kit covering both jobs instead of two separate setups. The net result is a car that changes direction with less lag between input and response, which is the difference you’ll actually feel lap after a hard session or a spirited B-road run.

About the Street Advanced coilover

Street Advanced is XYZ Racing’s core road-and-track product, refined over several years of development and validated through racing programmes run by teams worldwide. It’s built around 720 distinct damping settings, giving a genuinely fine adjustment range rather than a handful of coarse steps – useful when you’re hunting a specific balance between ride comfort and body control. The kit is aimed squarely at drivers who split their time between normal road use and track days, rather than being a dedicated race-only product. Construction targets consistent damping response across that adjustment range, so changes at one end of the dial behave predictably relative to the other. For an S3 Sportback owner, that translates to a coilover that can be dialled soft enough for daily commuting and firm enough to hold its own on a circuit, without needing to swap parts between the two.

Fitment for the Audi S3 SPORTBACK 8V φ55 (Cancellation Kit for Electronic Damping) (2013-2020)

This kit is built specifically for the Audi S3 Sportback 8V chassis produced 2013 to 2020, with the φ55 strut specification and the cancellation kit required to run fixed damping on cars fitted with factory electronic dampers. Confirm your car falls within this production window and carries the electronic damper system before ordering, as the cancellation hardware is specific to that configuration.

What buyers also search for

• Audi S3 Sportback 8V coilover upgrade for road and track use
• Audi S3 8V electronic damper cancellation kit for aftermarket coilovers
• Audi S3 Sportback suspension with adjustable ride height and damping
• Audi S3 8V quattro handling upgrade for fast-road and trackday driving
• XYZ Racing Street Advanced coilover fitment for Audi S3 Sportback

Spec your ride height and damping range for the 8V S3 Sportback and configure yours below.