XYZ Racing Drag Racing Coilovers — Greatwall COOLBEAR 2009-2015

The Coolbear’s tall, boxy body and light front-wheel-drive layout were never meant for a drag strip, which is exactly why the launch is where this kit earns its place. On a standing-start run a soft factory front end lets weight pitch around instead of pressing down on the driven tyres, and you bleed time before you have even cleared the line. The XYZ Racing Drag Racing coilover for the Greatwall(长城) Coolbear(酷熊) exists to control that transfer.

This is a kit built around a single job: getting a 2009-2015 Coolbear off the line cleanly and keeping it composed at the top end. It sets the chassis up to load the drive wheels under launch, cut wheelspin, and hold the car steady once the speed builds.

What this coilover kit does for your 2009-2015 Greatwall(长城) Coolbear(酷熊)

The first thing you notice is the launch. The setup shifts load onto the driven wheels the instant you leave the line, so the front tyres bite instead of spinning and the dead moment between throttle and traction shrinks. Because the Coolbear is light and sits high, managing that initial pitch is most of the battle, and a firmer, properly valved front end keeps the nose planted rather than rising under power. Further down the strip the same control shows up as stability: less float, a flatter attitude, and a car that tracks straight as the speed climbs toward the trap.

About the Drag Racing coilover

The Drag Racing series is engineered for one discipline: the 0 to 400 metre run. XYZ Racing designed it to suit front, rear, and four-wheel-drive cars, because the same principle holds whatever the layout – bias the weight toward whichever axle is putting power down. On launch the coilover deliberately alters the front-to-rear balance so the driven tyres are pressed harder into the road, increasing their compression and the contact patch they generate. That added load is what trims the idle phase where a wheel spins without driving the car forward. The result is a quicker, more repeatable getaway and a chassis that stays settled at high speed rather than wandering. For a front-wheel-drive Coolbear it means the weight works for you over the front axle, exactly where the traction has to come from.

Fitment for the Greatwall(长城) Coolbear(酷熊) (2009-2015)

This kit is matched to the Greatwall(长城) Coolbear(酷熊), chassis code GR01, covering the 2009 to 2015 model years. It is specified for that platform, so the mounting points and ride-height range suit the car as built. Confirm your exact year against the range above before you order.

What buyers also search for

• Greatwall Coolbear drag racing coilovers for quicker, cleaner standing-start launches
• GR01 Coolbear suspension upgrade to load the front tyres and reduce wheelspin off the line
• Greatwall Coolbear coilover kit for high-speed stability down the strip
• 2009-2015 Coolbear drag setup for front-wheel-drive traction

Set your ride height and launch attitude to suit your Coolbear and your strip – configure yours below.