XYZ Racing Drag Racing Coilovers — Cmc J SPACE (OE Lower 50mm) 2024-2026

For standing-start 0-400 metre runs in the Cmc J SPACE, the limiting factor is rarely peak power – it is how cleanly the driven tyres bite when the lights go green. The XYZ Racing Drag Racing coilover for the 2024-2026 Cmc J SPACE is built around that single problem: getting load onto the driven axle the instant you take up drive, then keeping the chassis settled as speed climbs down the strip.

This is not a fast-road or circuit kit pressed into service at the strip. The Drag Racing series targets launch traction and high-speed stability specifically, and the OE Lower 50mm specification means it locates in the factory lower mounting points on the CM02 chassis without bracket fabrication.

What this coilover does for your 2024-2026 Cmc J SPACE (OE Lower 50mm)

Set up correctly, the kit moves weight rearward onto the driven wheels under hard acceleration, loading the contact patch at the point it counts most off the line. That added compression on the driven tyres cuts the dead time between throttle application and forward drive – less wheelspin, more of your power turned into trap speed. Because the J SPACE platform appears in front-, rear- and four-wheel-drive form, the damping can be biased toward whichever axle is doing the driving on your car. Past the eighth-mile, the same settings keep the body flat and the steering honest as the car nears terminal speed, so a quick run does not go nervous at the top end.

About the Drag Racing coilover

The Drag Racing coilover is engineered for one discipline: 0-400 metre acceleration. Where a road or track kit chases balance through corners, this one is tuned to manage longitudinal weight transfer – the way load shifts between the front and rear axles the moment the driven wheels are asked for everything. The valving lets the chassis squat onto the driven axle in that first instant of drive, forcing greater compression into the driven tyres and shrinking the window where the wheel spins instead of hooking up. It suits front-wheel, rear-wheel and four-wheel-drive applications, with the setup adapted to where the drive is going. Height adjustment lets you set ride height and corner balance for the strip, and the OE Lower 50mm version uses the standard lower fitting to keep installation on the Cmc J SPACE straightforward.

Fitment for the Cmc J SPACE (OE Lower 50mm) (2024-2026)

This kit is matched to the Cmc J SPACE, chassis code CM02, across the 2024 to 2026 model years. It uses the OE Lower 50mm mounting, so it sits in the factory lower points. Confirm your chassis code and drivetrain layout in the configurator before ordering so the spec lines up with your exact car.

What buyers also search for

• Cmc J SPACE drag racing coilovers for quicker, cleaner 0-400 metre launches
• Cmc J SPACE suspension setup tuned for launch traction rather than circuit balance
• CM02 coilover kit for FWD, RWD and four-wheel-drive J SPACE builds
• Cmc J SPACE drag coilovers using the OE Lower 50mm factory mounting
• 2024-2026 Cmc J SPACE drag strip suspension for high-speed stability at the top end

Set your spec for the Cmc J SPACE – ride height, drivetrain bias and damping – using the configurator below. Build yours below.